Cc3d Motor Wiring Diagram

If you are just testing the CC3D board, you can skip this step. www.geeetech.com Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 - 858 - 13 - GEEETECH ShenZhen GETECH CO.,LTD. Figure 3-9. Connect the motor and ESC, make sure power supply is normal. Click start button below and slide the slider to the right until the motor starts to spin stable... The CC3D is a powerful and affordable flight controller that is very popular to use mainly on miniquad copters due to its small form factor. It has many advanced features that you can use if you add a GPS module, even waypoint based flight,. However, most users don't bother with this for mini quadcopters and just want the basic setup. This post will provide some links and comments to some of.

Wire up the ESC to the CC3D as per the diagram, press 'Save' to close the diagram and press 'Next'. Ensure your aircraft is on a level surface and press the 'Calculate' button to calibrate the flight controller. Read the instructions very carefully on the ESC Calibration window. Tick all 3 of the safety checkbox once you understand the.. The CopterControl, CC3D and Atom flight controllers are all types of stabilisation hardware which run the OpenPilot firmware. They can be configured to fly any airframe from fixed wing to an octocopter using the OpenPilot Ground Control Station (GCS) software.. (Vcc) and negative (Gnd) pins are indicated on this diagram and the board. Servo.