Therefore the SaluSpa should be installed near a floor drain. • Do not leave the spa's surface exposed to direct sunlight for long periods of time. GFCI Test IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED BEFORE TURNING ON THE PUMP EACH TIME. Plug the GFCI into a power outlet. Press the reset button, the indicator turns red.. Press the "Temp Up" button and then the "Jets" button. Step 2. Press the "Temp Up" button again to choose a cycle. The display will read "F1" to indicate a one-hour filtration, "F2" for two hours, "F3" for three, and so on. Step 3. Reset the Coleman Spa controls again. Turn the spa off, wait 30 seconds and turn it back on again. The controls.
![Coleman SaluSpa Setup video (2021) [RU] YouTube](https://i.ytimg.com/vi/AAklwiEvM4k/maxresdefault.jpg "Coleman SaluSpa Setup video (2021) [RU] YouTube")
.jpg?impolicy=medium "Coleman SaluSpa 6 Person Inflatable Spa Bubble Massage Outdoor Hot Tub")
this is for a Coleman saluspa inflatable hot tub. Pool and Spa Expert: Randy Huckstadt. Good afternoon!. Possible manual reset button located on your spa pack heater. Turn spa off push button down and run power back on. Customer. ok thanks. Pool and Spa Expert: Randy Huckstadt.. must be tested before each use. With the product operating, push the test button on the GFCI and the product should not operate. Push the reset button on the GFCI and the product should now operate normally. When the product fails to operate in this manner, there is a ground current flowing indicating the possibility of an electrical shock.