Adding a sensor is easy - just wire your soil or moisture sensor to one of the 4 sensors on the new controller hardware and then create the sensor in the reports have also been updated to show your sensor levels. Our level-based sensors will work with any type of contact-based sensor which is normally open or closed.. Enhancing your controller's capabilities is as simple as connecting a Sensor to the designated sensor ports. Our software seamlessly accommodates a wide range of standard open/closed contact sensors, including those for rain detection, soil moisture measurement, and other ON/OFF sensors. Furthermore, with Hydrawise, you can harness the power of flow monitoring by integrating it with a Hunter.
Sensor Wiring & Software Setup Hydrawise® Software supports standard open/closed contact rain sensors and soil moisture sensors. In fact, you can use any generic type of sensor that has an open/closed contact. These sensors use two wires and are usually labeled as normally open (sometimes called NO) or normally closed (sometimes called NC).. Hydrawise® Software supports standard open/closed contact rain and soil moisture sensors. You can use any generic sensor type with an open/closed contact.These sensors use two wires and are usually labeled as normally open (sometimes called NO) or normally closed (sometimes called NC).A rain sensor is used to suspend watering cycles for a zone (or zones).